Above values from ASTM A Higher strengths can be produced by heavy cold work – this may be required for certain applications. ASTM A – 16 Standard Specification for Stainless Steel Wire and Wire Rods for Cold Heading and Cold Forging. This specification covers. See the chemical composition and physical properties of ASTM A Grade annealed Stainless Steel, find alternative materials, and connect with suppliers.
|Published (Last):||8 March 2006|
|PDF File Size:||6.6 Mb|
|ePub File Size:||3.26 Mb|
|Price:||Free* [*Free Regsitration Required]|
Such requirements may include, but are not limited to the following: Link to Active This link will always route to the current Active version of the standard. An electroplated copper coating is often used.
Your comments will receive careful consideration at a meeting of the responsible technical committee, which you may attend. Your comments are invited either for revision of this standard or for additional standards and should be addressed to Aetm Headquarters.
ASTM A493 – 16
For smaller sizes, similar mechanical properties apply to ferritic and martensitic grades; however the producer should be consulted regarding somewhat higher tensile properties applicable to austenitic grades. Originally published as A — This specification covers cold-finished and hot-finished stainless steel wire and wire rods for cold heading or cold forging for applications, such as fasteners, where corrosion resistance is a factor. a93
Packaging and Package Marking 9. Users of this standard are expressly advised that determination of the validity of any such patent rights, and the risk of adtm of such rights, are entirely their own responsibility.
Historical Version s – view previous versions of standard. The values given in parentheses are mathematical conversions to SI units adtm are provided for information only and are not considered standard.
ASTM A for Stainless Steel Wire and Wire Rods for Cold Heading and Cold Forging
General Requirements for Delivery 4. The SI equivalents are in parentheses and may be approximate. Material can be manufactured to tensile strength ranges other than those shown in A943 2. The following coatings may be specied: A superscript epsilon e indicates an editorial change since the last revision or reapproval.
ASTM A493 Grade 384 annealed
This abstract is a brief summary of the referenced standard. A number in parentheses indicates the year of last reapproval. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract qstm accurate, complete or up to date.
Last previous edition A — B Product analysis tolerance over the maximum limit for carbon and nitrogen to be 0.
It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ICS Number Code Resistance to Intergranular Corrosion 8.
The American Society for Testing and Materials takes no position respecting the validity of any patent rights asserted in connection with any item mentioned in this standard. The producer should be consulted when material is required to tensile strength ranges other than those specied. NOTE 1—A typical ordering description is as follows: This standard has been approved for use by agencies of the Department of Defense. All austenitic grades in the annealed condition or annealed and lightly a4933 condition shall be capable of passing the criteria set by this specification.
Current edition approved Jan.
Copyright ASTM Standard Specication for Stainless Steel Wire and Wire Rods for Cold Heading and Cold Forging1 This standard is issued under the xed designation A ; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision.
This standard is subject to revision at any time by the responsible technical committee and must be reviewed every ve years and if not revised, either reapproved or withdrawn. The steel shall conform to the required chemical composition requirements. Soap is generally used. The material shall also conform to the requirements as astmm mechanical properties. Referenced Documents purchase separately Awtm documents listed below astn referenced within the subject standard but are not provided as part of the standard.
The following lubricants may be specied: