D CV. Read this owner’s manual thoroughly before use Owner’s operation manual for series. DT Series. 3 1/2 Digital Multimeter. Read this owner’s manual thoroughly before use. DT series multimeter have been designed according to IEC concerning electronic measuring. View and Download Histest DT owner’s operation manual online. DT Multimeter pdf manual download.
|Published (Last):||8 July 2009|
|PDF File Size:||12.10 Mb|
|ePub File Size:||7.22 Mb|
|Price:||Free* [*Free Regsitration Required]|
A test signal will appear between the and “COM” jacks. To use safely, each measurement can not last mznuale more than 10 seconds, and the interval between each measurement must be more than 15 minutes.
Safety Information If the defect has been caused by a misuse or abnormal operation conditions, the repair will be billed at a nominal cost. Don’t show me this message again.
Histest DT830 Owner’s Operation Manual
Set the range switch to ” ” or ” ” range. Before measuring current, check the meter’s fuses and turn power off to the circuit before connecting the meter to the circuit. Battery And Fuse Replacement Before attempting to open the case, always be sure that test leads have been disconnected from measurement circuits. Before attempting to open the case, always be sure that test leads have been disconnected from measurement circuits.
Owner’s operation manual for DT Series 3 ½ Digital Multimeter
If the defect has been caused by a misuse or abnormal operation conditions, the repair dt80d be billed at a nominal cost. Use the proper terminals, function, and range for your measurements. Page 6 To use safely, each measurement can not last for more than 10 seconds, and the interval between each measurement must be more than 15 minutes.
Got it, continue to print. Front Panel Description This function allows the meter to output a manusle as a signal generator. To print the manual completely, please, download it.
This function allows the meter to output a signal as a signal generator.
Table of Contents Add to my manuals Add. The voltage is approximate 5Vp-p. Operating Instruction “COM” jack.
Enter text from picture: Disconnect circuit power and discharge all high-voltage capacitors before testing resistance, continuity, diodes, or capacitance.
Comments to this Manuals Your Name. Set the range switch to mxnuale desired range. Close case and tighten screws completely before using the meter to avoid electrical shock hazard. Related Manuals for histest DT No related manuals.
If the resistor to be measured is connected to a circuit, disconnect circuit power and discharge all capacitors before measuring maunale. Don’t have an account?
HISTEST DT OWNER’S OPERATION MANUAL Pdf Download.
In the latter case, the transient stresses are variable; for that reason, its necessary that the transient-withstand -capability of equipment is made known to the user. By pressing ‘print’ button you will print only current page.
A coupling capacitor should be used when connecting the meter to a circuit.
Page of 13 Go.